Troubleshooting Guide | No Go Gage Problems

Solution: Select proper size from Spiralock Drill Chart

Solution: Realign spindle or possibly rebuild spindle assembly to achieve accuracy required

Solution: Check that part is fixtured correctly and movement of part does not occur during tapping operation

Solution: Change to a rigid tool holder, if gauging is correct, then replace toolholder

Solution: Decrease feed pressure, thereby letting tap freely cut at its own lead

Solution: Replace tap

Solution: Increase amount of coolant, direct coolant to end of tap

Solution: Clean out chips before tapping or drill minor diameter deeper to provide more area for chips

Solution: Obtain material specifications and consult Spiralock sales for correct style tap.

Solution: Return gage to Spiralock for recertification or purchase new gage