Troubleshooting Guide | Go Gage Problems

Solution:Regrind or replace tap

Solution: Remove burrs from thread

Solution: Select proper size from Spiralock Drill Chart

Solution: Tap and hole are not aligned correctly. Check alignment with dial indicator.

Solution: Check that correct lead is programmed into controller or check condition of lead screw

Solution: Change clamp points in fixture to remove stress from tapped hole

Solution: Use proper reversing speed when exiting hole and clear tool completely from hole when finished tapping

Solution: Discard tap and use a new tap

Solution: A common problem when tapping thin walled tubing or materials that are elastic. Increase tapping speed and feed. Change to tap with more flutes to decrease cutting pressure

Solution: Verify gage has been recertified recently or thoroughly clean debris from gage.